LUME Wood V2 Print Queue

The wood enclosure replaces the large 3D-printed outer bar shell and rear pod. Do not print the old shell halves or pod halves for this version. The printer is now used for the precision support pieces that make the wood body usable: camera mounts, sensor shelves, K11 tray, cable clamps, fan parts, and service plates. - Printable CAD source: `../lume-wood-v2-printables.scad` - STL exports: `../exports/wood-v2/` - OrcaSlicer projects: `3mf-current/wood-v2/` - Preview renders: `../renders/wood-v2-printables/` - Wood fabrication spec: `../wood/LUME_WOOD_ENCLOSURE_SPEC.md` Open these in OrcaSlicer, inspect the plate, then slice/export G-code from the GUI. | Plate | Orca project | Parts | Purpose | |---|---|---|---| | 01 | `3mf-current/wood-v2/01_wood_v2_small_fit.3mf` | 2x Arducam mounts, NF-A8 grille, NF-A8 spacer, USB service plate, display cable clamps, zip-tie anchors, feedthrough radius template | First validation plate. Confirms printer settings, fan hardware fit, Arducam mounting, cable routing hardware. | | 02 | `3mf-current/wood-v2/02_wood_v2_sensor_stack.3mf` | Mega shelf, Bolt shelf, sensor side-rail pair | Builds the stacked Mega/Bolt shelf tower for the wood front bar. | | 03 | `3mf-current/wood-v2/03_wood_v2_k11_sled.3mf` | Universal sled base, K11 adapter plate | Holds the K11 in the rear wood pod with bottom-fan clearance. | 1. Print Plate 01 first. This replaces the old shell-joinery coupon gate for the wood version. 2. Test-fit the NF-A8 FLX fan against the grille/spacer and verify the 71.5 mm hole pattern. 3. Test-fit both Arducams against the two printed mounts before drilling the final front panel holes. 4. Print Plate 02 only after confirming the wood front-face window layout is still the stacked Mega-lower/Bolt-upper design. 5. Print Plate 03 after confirming the K11 will sit in the rear pod with ports facing the rear service window.